It shows the S/N and the port that drive is attached to. To speed up the process you should provide us with the above output. To replace a failed drive just contact us, we will immediately take care of it. RAID MONITOR PROCCESS FULLSupported Power States : Full power,Powered off,Standby Reported Location : Connector 0, Device 0 To check if there is any failed drive (in this scenario the SSD failed), type in the following command and you will see the “State : Failed” information: “ZMM not installed” shows that this controller currently has no BBU (battery backup unit) installed, a BBU can be installed at any time as an upgrade.Ī “Degraded” status on a LD (Logical Device) indicates that there must be an issue. \arcconf.exe GETCONFIG 1 | findstr Status The most important status can be filtered out by typing “.\arcconf.exe GETCONFIG 1 | findstr Status” into the Powershell. In case you have installed more than one controller you could display the information of the 2nd controller by typing “.\arcconf.exe GETCONFIG 2”.Ī list of available options can be displayed by typing “.\arcconf.exe”. You will get all information regarding the 1st controller installed in your system. \arcconf.exe getconfig 1″ – this will display all information. You should be able to run the executable by using the following command: ”. Open the Powershell and change the directory using the following command: You should see some directories including the “windows_圆4” directory, select that directory and copy it to “C:\raid\”. (You could also download the binary with your webbrowser from here ) The binary can be downloaded via Powershell as well, type in the following command: Open the Powershell as Administrator, you will start at the “Administrator” User folder.Ĭreate a new folder and change to that folder, e.g.: Adaptec 1.1 Installation of the arcconf binary RAID MONITOR PROCCESS DRIVERUpdating the controller’s firmware or the operating system’s driver may lead to a complete loss of all data stored on that RAID! 1. Please contact our support department in case you are not sure which controller was added to your server. There are also graphical interfaces available for managing raidcontrollers, such as a web interface. This blog entry shows the installation and use of the Adaptec and LSI software on Windows operating systems. In the case of a software RAID, the operating system generates messages about the RAID with a hardware RAID, the controller does it itself – but you need a special software to read these messages. We always rely on tried and tested hardware to minimize the risk of a hardware failure, but there is always the risk that hardware fails, therefore monitoring the hardware is even more important to guarantee that the server will keep running properly. Below you can find the respective guideline for Windows.Ī hardware RAID has certain advantages, but also a hardware RAID has to be monitored. RAID MONITOR PROCCESS HOW TONot long ago, we have shown you in a different tutorial how to manage your raidcontroller in Linux.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |